Lab Gruppen FP 6400 Power Amplifier

Mensaje publicado por andres novelo el Octubre 15, 2006 a las 18:49:29:

saludos a todos los doperos weno solo para ver si alguien me puede dar su opinion acerca de los Lab Gruppen FP 6400 Power Amplifier ya que encontre que es mas caro que crown y da mas poder e aqui las caracterisicas de este :

Lab Gruppen FP 6400 Power Amplifier Features:

* DC protection: protects against infrasonic signals
* VHF protection: protects the loudspeakers against strong very high frequency non-musical signals above the audible range.
* Thermal protection: prevents the amplifier from being overheated. The protection indicators on the front panel are switched on, as a warning, before the protection process is initiated.
* AC protection: shuts down the power supply if the line voltage is outside the operating voltage.
* Clip limiter: prevents severely clipped waveforms from reaching the loudspeakers, whilst maintaining full peak power
* 2 x 1300 watts @ 8 Ohms
* 2 x 2300 watts @ 4 Ohms
* 2 x 3200 watts @ 2 Ohms
* (Measured just below clip level, with both channels driven)
* Compact design, 2U high
* Low weight,10 kg (22 lbs)
* MLS Switch:Lab.gruppen s unique power matching for different loads
* Multiple positions gain switch
* Intercooler cooling system with front-to-rear airflow and easily accessible dust filters
* Improved low-end power bandwidth
* Link connector with XLR-type connector
* Bridged mono outputs in one Speakon connector
* Extruded front panel for increased stability

Lab Gruppen FP 6400 Power Amplifier Specifications:

* Max output power 1) EIA EIA EIA EIA FTC
* EIA at 1 kHz and 1% THD 20 20 kHz at 0.1% THD
* MLS-switch 5 dB 4 dB 2 dB 0 dB Full 0 dB Full
* 16 Ohms per channel 220 W 260 W 410 W 650 W 640 W
* 8 Ohms per channel 430 W 520 W 820 W 1300 W 1280 W
* 4 Ohms per channel 830 W 1000 W 1600 W 2300 W 2200W
* 2 Ohms per channel 1660 W 2000 W 2400,30503) W 29002),32003) W 2500 W
* 16 Ohms bridged 860 W 1040 W 1640 W 2600 W 2500 W
* 8 Ohms bridged 1660 W 2000 W 3200 W 4600 W 4400 W
* 4 Ohms bridged 3400 W 4000 W 4800,61003) W 58002),64003) W 5000 W

Max output voltage
* 8 ohms load 62 Vrms 70 Vrms 85 Vrms 104 Vrms
* Peak voltage,no load 88 V 101 V 121 V 149 V
*
* Distortion etc.
* THD 20Hz-20kHz and 1W to full power 0.1 %
* THD @ 1kHZ and 1dB under clip 0.04 %
* DIM 30 at 3dB under clip 0.06 %
* Hum and Noise < 110 dB
* Channel separation @10kHz 70 dB
* Output impedance 60 m_
* Slew Rate 20 V/s
* Inputs
* Gain,selectable [dB] 20,23,26,29,32,35,38,41
* Impedance 20 kohm
* Common mode rejection 50 dB

Front Panel
* Gain controls (2) channel A,B 31 pos detent
* Clip Indicator (2) red LEDs
* Output headroom
* indicators (10) green LEDs Fast peak slow release
* Temp Indicator (2) yellow LEDs 80øC at heatsink
* VHF indicator (2) yellow LEDs >12 kHz at full power
* On Indicator (2) green LEDs DC rail voltage for
* channel A and B
* AC Indicator (1) green LED AC power present
* AFS Indicator (1) green LED Fuse saver activated

Rear Panel
* Input connectors (2) Neutrik Combo XLR type,3 pin
* and 1/4 _ jack
* Link connector (2) XLR type,3 pin male
* Output connectors (2) Neutrik 4-pole Speakon© connectors
* Switches:
* Clip limiter A and B On Off(switchable)
* MLS switch 0, 2, 4, 5 dB
* Link-switch Ch.A B
* Power 230 V version 115 V version
* Operation voltage 130 V 265 V AC 65 V 135 V AC
* Minimum start voltage 175 V 85 V AC
* Full output power
* at 4ohms 180 V 265 V AC 90 V 130 V AC
* Peak inrush current
* (Soft start limited) 5 A 5 A
* Current Draw @ 4ohms
* Quiescent power (no load) 1 Arms 2 Arms
* 1/8 offull power ( 9 dB) 6 Arms 12 Arms
* 1/3 offull power ( 5 dB) 14 Arms 28 Arms
* At full power (0 dB) 20 Arms 40 Arms
* @1 kHz 1% THD (AFS limited) (AFS limited)
* Net Dimensions
* mm 483 W x 88 H x 347 D
* inch 19 W X 3.5 H x 13.7 D
* Shipping Dimensions
* mm 560 W x 180 H x 500 D
* 22 W x 7.1 H x 19.7 D
* Weight
* Net 10 kg (22 lbs)
* Shipping 11.6 kg (25.6 lbs)

alguna experiencia algo weno muchas gracias

• Weno. Danny Avila (Dr. Clip) 22:22:09 10/15/06 (0)